Apple g5 case micro atx full#

The decision had to be made to either cut the floor, or the bottom of the case. Second priority was keeping the floor of the case clutter-free in the final presentation. As my Gigabyte system board is ATX form factor mounted all the way to the top of the G5 case, a top-rear mounted PSU wasn't an option it had to be in the bottom. I wanted a clean unmodified plugin, no warranty voiding, easy replacement and the stock PSU cooling intact. I am aware that some members have done it successfully, but didn't consider it as an option for my build. My first priority was that I didn't want to disassemble the ATX PSU. Modular ATX PSU's are more adaptable, but nonetheless still have to supply power to a lot of components spread around the system. Second, the mass of wires coming out of the ATX PSU presents a huge challenge to effectively conceal from view. I hadn't peeled off the protective film yet, as this was just an initial test fit.Īdapting an ATX PSU to the G5 is perhaps the single most critical factor in the final outcome of the project.įirst, the height of the ATX and G5 are some 25mm different, with the ATX being an inch taller and needing either modification or retrofitting to conceal the excess height. Pics of Laser Hive tray (2 pcs) and backplate kit mounted to my G5 Case.

Apple g5 case micro atx full#

Laser Hive now makes a full ATX (7 slot) kit. I only have access to four of the available slots on my ATX board, but wanted to keep the look of the original numbered (1-4) PCI slots on the back of the G5, as I won't have any use for the other three slots. He also offers a backplate for a single 120mm fan. I wanted to utilize the G5 2x92mm rear fan assembly, so I used his original backplate kit. The tray I used was for an ATX board, he actually cut the tray into 2 pieces so I could switch to Micro ATX later if I wanted. He shipped the products with concise instructions and meticulous packaging at a great price. His workmanship is incredible, as he laser cuts the pieces to precision accuracy. Step 2 - The Motherboard Tray and BackplateĪfter reviewing the options available, I decided to purchase the tray and backplate from David Chugg at Laser Hive. The time and money I spent obtaining extra screws, power supply and other misc required items would have been eliminated if I had just bought a complete unit. After having completed this project, I would recommend buying a complete or non-working G5 and then gut it out, keeping all parts. I got a case that had standoffs placed much differently than I expected. I will add that there are 2 different layouts of standoffs on the G5 cases, specific to which motherboard was originally installed. The rest of case is 95%, not bad for a piece of hardware that's almost 10 years old. Left it for 48 hours before unclamping and it turned out great. I repaired it with a couple of Irwin clamps and a careful application of JB Weld. Unfortunately when it arrived, the bottom rear corner (the curved part) of the foot was bent out about 1/4 inch. Finally I found one on eBay that looked good, so grabbed it for about 90 bucks. There's plenty out there, but getting one in clean condition takes some doing. Building a CustoMac Hackintosh: Buyer's Guideįinding the empty case took a bit of searching.